There Is Standing Water In My Water Softener Tank
Seeing standing water in your saltwater storage tank can be a little concerning. Isn’t it meant to just be salt? Well, that depends. For some households that don’t go through much water, this can be usual. Although you might need to add a bag of salt in the future, it’s absolutely nothing to cause an alarm system. Nonetheless, standing water can likewise signify a problem. The components that control water intake maybe letting the storage tank overfill or water is not being drawn down after regeneration. How can you tell? You may be asking yourself Why is there standing water in my water softener? Here are a couple of reasons there may be standing water in your water softener salt tank.
Inbound Brine Line Hose Pipe Is Disconnected
There is a float inside the salt well that controls salt level, like the float in your bathroom toilet tank. If the inbound water line is not firmly attached, the float will not stop the water circulation at the correct height. Check to confirm that the line and float are attached.
In all-time lows of the storage tank, salt clogging might be your problem. There are horizontal ports in the salt well that enable water to move in and out. If the salt buildup is clogging the storage tank at the bottom, that will minimize the amount of water that can enter the tank, absorb salt, and then flow back out. If this is your problem, it’s time to clean the container.
Drain Pipe Malfunction
If the drainpipe line has become blocked, has a kink in it, or is harmed, clean or replace it. This is a simple fix to your problem.
Blocked Drainpipe Circulation Control
If the line itself is ok, detach the line as well as see if the control shutoff has actually become clogged. This is a typical concern in homes where the water has a high iron content. If you see the build-up, merely clearing out the control shutoff may fix your issue.
Blocked Salt Water Line
If debris builds up in the salt well, it can at some point clog the line. Flushing it out might address the problem.
Salt Water Level Control
If the float, as well as the incoming line, is firmly attached, the float itself might be the problem. If it comes to be clogged, it cannot open, so it’s a great idea to remove it for cleansing. Keep in mind that there is expected to be a cap in addition to the salt well– if it is missing, salt can enter the well and also cause obstructions.
This is another common problem (again, specifically if your water has high iron web content) that can be dealt with by removing and also cleaning the injector. There is a tiny opening that regulates intake suction. You can use a wooden toothpick to cleanse it, but do not use anything steel since you can easily damage the injector by modifying the size of the hole. You can likewise make use of a cleaning item such as Calcium Lime Rust (CLR) eliminator. If you aren’t able to cleanse the injector, you will certainly need to change it.
Is the base plate on your electric water conditioner lit up as it should be? If not, that suggests there is trouble with the circuit card as well. This indicates it needs to probably be replaced.
Malfunctioning Spacer Stack And/or Positions
The problems we have actually already talked about are most common, yet gradually the spacer stacks, as well as pistons in your water softener, will certainly also wear. You can verify that this is the problem by separating the drain line as well as the saltwater line while the valve is running. If you see the water is moving over the valve, it’s time to change the spacer stack and also pistons. Replacing the base plate, spacer stack, or pistons is not a DIY project. The very best thing you can do is call an expert. Whether the problem is basic or difficult, adhering to these fixing tips will certainly aid you to deal with the problem of standing water in your water softener salt storage tank.
For more information on Water Softeners and filters contact our professionals today.